called the drilling will start in which the center hole, is often a starting point for the traditional twist drill. Fixtures & Tooling: The tool has been used in the first part of the film bore a tungsten carbide insert body. In this case, we have decided to use a spot drill, to ensure that the second tool that we use do not migrate from the drill bit to mark it. We used a drill cycle G73 with a feed rate of 1.7 inches per minute. The program in the second part of the film was used, a traditional ...
http://www.youtube.com/watch?v=98DvSQNHLMU&hl=en
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment